Dynamic Settings CLI Command

The CLI command for dynamic settings has two sub-commands:

$ cobbler setting --help

usage

cobbler setting edit cobbler setting report

cobbler setting edit

This command allows you to modify a setting on the fly. It takes affect immediately, however depending on the setting you change, a "cobbler sync" may be required afterwards in order for the change to be fully applied.

This syntax of this command is as follows:

$ cobbler setting edit --name=option --value=value

As with other cobbler primitives, settings that are array-based should be space-separated while hashes should be a space-separated list of key=value pairs.

cobbler setting report

This command prints a report of the current settings. The syntax of this command is as follows:

$ cobbler setting report [--name=option]

The list of settings can be limited to a single setting by specifying the --name option.


comments powered by Disqus